Search This Blog

Monday, November 11, 2019

Display On Timer with 555

This is related to the earlier post. This was done to save battery power. The output of some equipment may be in the form of LED Annunciators In the Security Guard Monitor, an Array of 24 LEDs would show the Status of alertness along with the day, this was scrollable.

Display On Timer with 555

When the "Display Now" is pressed it triggers the Monostable Multivibrator made of a 555. The output "EN" goes high for the time duration defined by C27 and R71.

The 555 output as you know can drive more than 200mA for quite some time without much heating up. Many LEDs can be driven with the current limit resistors. I used CMOS chips to drive the LEDs, this circuit was used for the Logic only.

Hobby Projects - LED Circuits and Small Test Tools.

This circuit was a part of the user interface like the previous one. You could use it for voltmeters or even backlight for LCD.

Example - When you press the switch the Time of a clock can be seen in darkness for a few seconds.

Drive SCR thyristor with 555

This circuit gives a burst of pulses to fire 2 SCRs, when pin 4 is taken to 12V the SCR is turned on, to use this circuit you need 12V short pulses phase shifted with respect to AC sine wave on bridge, like this you can control the bridge from near 0% to near 100% ON.

Drive or Fire Thyristors SCR with Pulses

Drive SCR thyristor with 555

Learn about Thyristors here Power Electronics

That way battery banks can be charged, electroplating can be done, current and voltage can be controlled with opamps, thyristors are very rugged compared to transistors and MOSFETS in that order.

OR gate with two 555

This shows how to OR gate two 555, when one 555 cycles at a low frequency a valve turns on an off, the second 555 stretches the ON duration of the pulse with a diode OR gate.

OR gate with two 555

The OR output uses sample and hold to get the stable analog data from a sensor after the actuator has gone OFF, this ensures correct reading.

OR gate with two 555

555 is a fundamental Mixed Signal Circuit as it can be made into a VCO using Pin-5. If you see old exar databooks, you can see 555 and PLL and Tone decoders all applications compiled in one base. I feel the Venerable Signetics 555 "Architecture" and Intersil ICL8038 'CMOS' were inspiration behind early communication chip designs, Moving from Bakelite Telephones to Compact Push Button Electronic Phones and more.