Tuesday, October 13, 2015

Linearizing Circuit for Thermocouples

This circuit changes the gain of opamp U1B in four steps or segments. It can be used to get a linear output from most transducers to 1% levels.U1A is a amplifying buffer use it to boost the signal to the required level.
Linearizing Circuit for Thermocouples

The resistor values i have put are for an imaginary transducer, you have to design them. The buffered input signal is compared to reference switching points by LM339.

Temperature Measurement and Control

LM339 changes the gain resistors of U1B thru the mux switch 4066. JP1 to JP4 can select either amplification or attenuation of signal. The resistor switched by 4066 can be across R1 or R2 based on JP1 to JP4.

You may have to input transducer values into a spreadsheet and draw a graph. Then divide the graph into 5 segments and deduce the switch points and gain.

Wednesday, October 07, 2015

PLL using 4046 - Phase Locked loop

CD4046 is a PLL or phase lock loop, it mainly consists of a VCO and phase comparators. This is a component in FM demodulation and modulation.

Mixed and Interface Circuits

PLL using 4046

It is used in a closed loop control to maintain a stable frequency. The Circuit above is good for learning the full use of a small Dual Trace Scope. The Circuit has both Analog and Digital areas and is a part of communication.
Read the pages above for building more Knowledge on PLL

Monday, October 05, 2015

Thermocouple Amplifier Standard

Thermocouple is the most common sensor in Industrial Temperature Measurement. The Signal Conditioning involves Cold Junction Compensation and High Gain DC Amplification. The output of a Themocouple is in millivolts. 

The OP07 is a low offset 75uV opamp, here it is used to amplify the output of a Thermocouple, the gain of this stage is high. The zeners are to protect any high voltage at input zapping the opamp.

Thermocouple Amplifier Standard

The Resistor R6 limits the current. The zeners should be low leakage or use clamping pull-up and pull-down diodes to +5 and -5 respectively.

The RC low-pass filter formed by R6 and C2 reduce the mains hum or 50 Hz pickup of long thermocouple cables laid close to high current heater wiring. R1 is a offset null use or add if required. R11 is gain control of OP07. The TL072 is a FET input opamp used here as a summing amp.

Blind Dial Proportional Temperature Controller

Adding one more inverting amp with some gain to the output of this circuit can give you a 1-5V suitable for ADC or PC analog I/O cards. C1 also serves to filter, it is an integrator here. It suppresses EMI and RFI from motors, contacters etc., R13 sets an output value for 0mV input.

Hobby DIY Electronics