Saturday, May 17, 2014

555 watchdog for uC and uP systems

When the microcontroller hangs due to a spike, EMI or RFI etc. the 7555 will reset the uC, if proper power supply design is done above circuit can also give a clean power on reset, the above circuit you should modify to suit your design.

80C39-8749 MCS-48 Examples and code

Better still use a uC with watchdog built in like some atmel chips, or use the watchdog chips from maxim which can also do RAM battery management.

The circuit was developed over a old TI application note, 7555 i think fairchild may be making it, 7555 is CMOS version of 555 timer, advantage of 7555 is that it can go to higher frequency, low power consumption, the disadvantage is its output drive mA is not as good as 555. now why i put it here was that you can see how charge and discharge paths are separated with diodes.

555 watchdog for uC and uP systems

See Larger Circuit. 555 Watchdog
Edit the circuit eagle cad file del00013.zip,

Saturday, May 10, 2014

Fixed frequency Variable duty cycle with 555

This circuit is based on a very old application note from exar, in this the frequency is fixed by IC1 and IC2 -P1 controls the duty cycle. you need to compute the R and C values to get what you need,  LM555 data sheet.

You have to study the circuit and do something more innovative perhaps, just copying is ok for learning but it will get you nowhere, so learn and then innovate, the eagle circuit is given below so you can learn by editing it, also design a PCB with it, and you can even make a PCB at home to learn, but it is always good to get PCBs done by a PCB vendor, but you should understand his problems, then you will design well, so make a few PCBs.

Fixed frequency Variable duty cycle with 555

Edit the circuit eagle cad file del00012.zip,

Friday, May 02, 2014

Pulse width modulation using 555

IC1 astable gives a fixed square wave at pin 3, C1 and R1 derive uS trigger pulses from IC1 and this will trigger IC2 monostable or single shot, the voltage at pin 5 of IC2 will change the pulse width output of IC2, to get it working all the three RC combinations have to be figured out.

Optical Obstacle Switch.

You can even build a small SMPS with this or even control the temperature of your soldering iron using the SSR solid state relay circuits in power section, then you need to think and design the cycle time of a soldering iron heat control system, it will be in seconds but then above circuit is running at audio frequencies, then you have to work that out yourself..

Pulse width modulation using 555

Hobby DIY Electronics